X
Filaflex
  • 1,75 mm

  • +-0.05mm tolerance

  • Printing temperature (225-260 °C) depending your hotend and extruder.

  • Print speed (20-110 mm/s)

  • High adhesion with 3d printed bed

  • Do not need heatbed

  • Do not need kapton or blue tape.

  • Do not need hairspray or special adhesion spray

  • Odorless

  • Resistant to acetone, fuel and solvent. 

COMPATIBILITY

Filaflex is different to print with than rigid filaments in your 3d printer, but with a proper configuration you can do it without problems, for this reason it´s compatible with almost any printer.

HOW TO START PRINTING WITH FILAFLEX?

Recreus recommend that you first read the following article.

If you don´t have the new Recreus extruder, or your hotend is not optimized with a PTFE liner inside, Please follow these recommendations.

  1. Print speed 20mm/S

  2. Print temperature (240 °C)

  3. None retractions or low distance (1mm retraction distance and 30mm/s speed)

  4. Increase the extruder flow if your plastic melt flow is not constant.(105-115%)

  5. Decrease the pressure of the idler bearing of your extruder in order to avoid filament clogging between the extruder gear and bearing.